Wire EDM for Aluminum 7075-T6
Wire EDM is used for 7075 aluminum when complex profiles, sharp internal corners, or features beyond milling capability are needed. The high zinc content machines well with EDM.
Recommended Machining Parameters
| Parameter | Value |
|---|---|
| Achievable Tolerances | ±0.02 mm |
| Surface Finish | Ra 0.4-1.0 μm |
| Cutting Speed | Fast — high conductivity |
| Feed Rate | Auto-tuned by EDM controller |
| Tooling Recommendations | Brass wire 0.20-0.25mm. Zinc-coated wire for speed. |
Expert Machining Tips
1
Similar parameters to 6061
2
Multiple skim passes for aerospace tolerances
3
Adequate flushing pressure
4
Deburr recast layer for fatigue-critical parts
Common Parts Made
Aerospace profiles
Slot features
Complex contours
Precision shims
Machining Challenges
- Recast layer must be removed for fatigue-critical aerospace parts
- Stress relief recommended after EDM