CNC Turning for Titanium Grade 5 (Ti-6Al-4V)
Turning titanium Grade 5 requires careful parameter control due to its poor thermal conductivity, high strength, and chemical affinity with tool materials. Rigid setups and sharp tooling are mandatory.
Parametres d'usinage recommandes
| Parametre | Valeur |
|---|---|
| Tolerances realisables | ±0.02 mm (±0.0008") |
| Etat de surface | Ra 0.8-3.2 μm |
| Vitesse de coupe | 40-80 m/min |
| Vitesse d'avance | 0.10-0.20 mm/rev |
| Outillage recommande | Uncoated carbide (S grade) or PVD coated. Sharp positive inserts. Consider PCD for finishing. |
Conseils d'usinage expert
1
Low cutting speeds — heat has nowhere to go
2
Maintain positive chip flow at all times
3
High-pressure coolant aimed precisely at cutting zone
4
Use C-style or rhombic inserts for better heat dissipation
5
Never recut chips — they work-harden instantly
Pieces couramment fabriquees
Medical implant shafts
Aerospace fasteners
Turbine shaft sleeves
Valve stems
Racing axle components
Defis d'usinage
- Chemical reaction with tool coatings
- Chip can ignite if too thin
- Spring-back causes dimensional issues
- Requires specialized coolant management