Wire EDM for Titanium Grade 5 (Ti-6Al-4V)
Wire EDM is an excellent process for titanium Grade 5, bypassing all the conventional machining challenges. It cuts titanium at the same speed regardless of its hardness and eliminates tool wear entirely.
Parametres d'usinage recommandes
| Parametre | Valeur |
|---|---|
| Tolerances realisables | ±0.02 mm |
| Etat de surface | Ra 0.2-0.8 μm |
| Vitesse de coupe | Moderate — similar to stainless |
| Vitesse d'avance | Auto-tuned by EDM controller |
| Outillage recommande | Brass wire 0.20-0.25mm. Dedicated EDM settings for titanium. |
Conseils d'usinage expert
1
EDM eliminates all titanium machining challenges
2
No tool wear — pure electrical erosion
3
Excellent for medical implant profiles
4
Hydrocarbon dielectric may be needed for some features
Pieces couramment fabriquees
Medical implant profiles
Aerospace complex features
Turbine blade roots
Precision aerospace fittings
Defis d'usinage
- Recast layer must be removed for implants
- Titanium forms tenacious oxide layer
- Slower than steel due to lower conductivity