Rapid Prototyping for Copper C110 (ETP Copper)
Copper rapid prototyping is used for thermal and electrical validation where conductivity testing requires the actual production material.
Recommended Machining Parameters
| Parameter | Value |
|---|---|
| Achievable Tolerances | ±0.02 mm |
| Surface Finish | Ra 0.8-1.6 μm |
| Cutting Speed | 100-300 m/min |
| Feed Rate | 0.05-0.15 mm/tooth |
| Tooling Recommendations | Sharp uncoated carbide or PCD. |
Expert Machining Tips
1
Sharp tooling essential for good finish
2
Challenging to machine — allow extra lead time
3
Specify if high-purity C101 is needed vs standard C110
Common Parts Made
Heat sink prototypes
Bus bar validation
Electrical contact prototypes
Machining Challenges
- Gummy material — surface finish may need extra passes
- Tarnishes quickly — may need protective coating