CNC Milling for Delrin (POM / Acetal)
Delrin is one of the best plastics for CNC milling, producing clean chips and excellent surface finishes. Its high stiffness allows tight tolerances to be held reliably.
Recommended Machining Parameters
| Parameter | Value |
|---|---|
| Achievable Tolerances | ±0.02 mm (±0.001") |
| Surface Finish | Ra 0.4-1.6 μm |
| Cutting Speed | 150-400 m/min (SFM 500-1300) |
| Feed Rate | 0.08-0.20 mm/tooth |
| Tooling Recommendations | Sharp uncoated carbide, 2 flutes with high helix for chip evacuation. O-flute end mills for fine finish. |
Expert Machining Tips
1
High speeds and feeds for clean chip formation
2
Use sharp tools to prevent melting
3
Air cooling is usually sufficient
4
Avoid heavy depths of cut on thin walls
5
Allow material to stabilize at room temp before final cuts
Common Parts Made
Gears and sprockets
Bearing bushings
Conveyor guides
Pump impellers
Precision spacers
Machining Challenges
- Chips can melt and re-weld if speed too high
- Material expands with temperature
- Cannot be painted or glued easily