CNC Turning for Titanium Grade 5 (Ti-6Al-4V)
Turning titanium Grade 5 requires careful parameter control due to its poor thermal conductivity, high strength, and chemical affinity with tool materials. Rigid setups and sharp tooling are mandatory.
推奨加工パラメータ
| パラメータ | 値 |
|---|---|
| 達成可能な公差 | ±0.02 mm (±0.0008") |
| 表面粗さ | Ra 0.8-3.2 μm |
| 切削速度 | 40-80 m/min |
| 送り速度 | 0.10-0.20 mm/rev |
| 工具推奨 | Uncoated carbide (S grade) or PVD coated. Sharp positive inserts. Consider PCD for finishing. |
専門家の加工ヒント
1
Low cutting speeds — heat has nowhere to go
2
Maintain positive chip flow at all times
3
High-pressure coolant aimed precisely at cutting zone
4
Use C-style or rhombic inserts for better heat dissipation
5
Never recut chips — they work-harden instantly
一般的な製造部品
Medical implant shafts
Aerospace fasteners
Turbine shaft sleeves
Valve stems
Racing axle components
加工の課題
- Chemical reaction with tool coatings
- Chip can ignite if too thin
- Spring-back causes dimensional issues
- Requires specialized coolant management