CNC Milling for Aluminum 6061-T6
Aluminum 6061 is one of the most popular materials for CNC milling due to its excellent machinability, good strength, and cost-effectiveness. It machines cleanly with minimal tool wear and produces an excellent surface finish.
Parametres d'usinage recommandes
| Parametre | Valeur |
|---|---|
| Tolerances realisables | ±0.02 mm (±0.0008") |
| Etat de surface | Ra 0.4-1.6 μm |
| Vitesse de coupe | 200-400 m/min (SFM 650-1300) |
| Vitesse d'avance | 0.05-0.15 mm/tooth |
| Outillage recommande | Carbide end mills with 2-3 flutes, uncoated or ZrN coated. HSS acceptable for prototyping. |
Conseils d'usinage expert
1
Use high spindle speeds (8,000-15,000 RPM) for optimal chip formation
2
Climb milling preferred for better surface finish
3
Use 3-flute end mills for efficient chip evacuation
4
Coolant recommended but not always required
5
Can achieve mirror finishes with proper parameters
Pieces couramment fabriquees
Housings and enclosures
Brackets and mounting plates
Heat sinks
Structural frames
Jigs and fixtures
Defis d'usinage
- Built-up edge at low speeds
- Material may gall on tool at insufficient chip load